Glossy 1001 Weathergold 2000 Pro

GLOSSY 1001 WEATHERGOLD 2000 PRO

SILICON BASED WATER REPELLENT COATING FOR STONE, BRICK AND CONCRETE SURFACES

Glossy 1001 Weathergold 2000 Pro is composed of Siloxane & Silane polymers dispersed in high boiling point solvent. It is used for water proofing of concrete & cementitious vertical walls of building because it penetrates deeply into the substrate & provides an effective water repellent protective costing. It does not change the appearance of the substrate & the water repellent coating is UV resistant and durable.

Areas of Application

  • Water proofing treatment for –
  • Cement painted surfaces
  • Concrete, mortar
  • Clay brick surfaces
  • Natural and artificial stones: Marble, Dholpur, Sand Stone, All Porous Stone
  • Mangalore tiled roofs
  • Corrugated AC sheet roofing, etc

 

Features & Benefits

  • Ease of application-Ready to use, simply brushable or spray applied.
  • Staining-Clear coating does not stain the treated surface.
  • Appearance-Does not change the appearance of exterior decorative coating.
  • Vapour transmission – Prevents entry of moisture into the wall, but allows moisture to evaporate out
  • Efflorescence – Prevents efflorescence
  • Economical-Cost effective
  • Penetration – Due to low viscosity, penetration is high, which provides the hydrophobic zone.

 

SURFACE PREPARATION

  • Surface should be dry and free from all debris, dirt, oil, grease, wax and all other contamination, which could prevent penetration.
  • Clean the saturated dirt of surface by thorough wire brushing, cleaning with compressed air followed by water washing.
  • Decrease oil & grease by using solvents like turpentine or thinners.
  • Allow the surface to dry completely before the application.
  • Seal the cracks with GLOSSY FILLING POWDER
  • Thorough wire brushing followed by sanding with emery paper is recommended.
  • Remove the existing paint, Nero or instant lime, etc, while treating internal damp walls.

 

APPLICATION

  • Apply one liberal coat of Glossy Weathergold 2000 Pro, simply by brushing evenly on the prepared surface.
  • Allow the surface to dry for a minimum of 24 hrs for best results.
  • Glossy Weathergold 2000 Pro can also be applied with an airless spray (0.07-0.1 N/mm2 pressure).
  • Apply second coat wet on wet to improve the penetration rate & performance.
  • Allow it to dry for 24 hrs.

 

Precautions

  • Do not dilute with water or by any other means.
  • Close the container lid properly after use.
  • Before applying over the natural stones like sand stone or Dholpur, sampling should be done on a small area to check its suitability.
  • Before taking up application on a large area, it is advisable to check the performance of the product on a relatively small area.

 

Coverage

On porous substrate-               5-6 Sq meter/litre

On Low porous substrate-      7-8 Sq meter/litre

 

Shelf Life & Storage

Shelf life is 12 months from the date of manufacturing in unopened condition

Store in a cool & dry place:

 

Health & Safety Precautions

Use rubber hand gloves & safety goggles, while using Glossy Weathergold 2000 Pro

Keep out of reach of children.

In case of contact with skin, wash with plenty of water.

Do not smoke during application.